- The condenser serves to remove the heat absorbed by the evaporator and compressor. - Type condens

..sekadar share information and exchange opinions about problems with air conditioning, refrigerators, home and some household electrical appliances .. as its own reference in another time .. hopefully can reliably forgot to mutual benefit .. I give my right and take the right course , the other if I returned there .. ^ _ ^
- Compressor plays a very important role in the system of the refrigerator. It pumping gas coolant into a whole system. Normally refrigerators use a reciprocating compressor of the type (sealed hermetic). 2. Evaporator / evaporator. - Evaporator serves to absorb heat from the food and beverages stored in the refrigerator. - Evaporator made of corrosion resistant metals such as copper and aluminum punto seco to make more effective heat absorption. - Refrigerator single door type freezer (freezer) has an evaporator that meets all parts of the crate so that each part has the same temperature of 0 C. - For refrigerators, a non freezer punto seco door, the evaporator is placed at the top, while the other part will receive a blast of cold from the evaporator section. 3. Defrost Timer / Defrost Timer. - Timer installed on the refrigerator without frost which serves to control the inflow of the thermostat to the fan, compressor and heater. - Timer commonly used is called punto seco 'defrost timer' which has 4 terminals. punto seco - Flow derived from the thermostat timer connected to terminals 1 and 3. Terminal 2 connects with timer and heater fuse. Terminal 4 connecting timer with compressor and fan motor. - When the timer does not work, the components associated therewith will be problematic. 4. Capacitors / Capacitor. - The capacitor serves to raise or rotate the electric motor (compressor / fan) so as to achieve full rotation. - Capacitors worked very brief when moving the compressor / fan and compressor immediately interrupted when rotation / fan reaches a maximum. 5. Overload Protector / Overload Protector. - Overload protection Overload Protector or the safety components for compressors. punto seco - It can protect electrical punto seco components from damage from the refrigerator the resulting flow compressor exceeds normal limits. - If the current in excess of current compressor proper, overload will decide the incoming supply to the compressor. punto seco 6. Relay / Relay. - Relay @ relay is an automatic switch to move the compressor motor. - It works by adjusting the rotation of the magnet is raised so that it can re-connect or disconnect the electric current punto seco automatically. Components no.7 up no.12 is shown below: 7. Condenser / condensor.
- The condenser serves to remove the heat absorbed by the evaporator and compressor. - Type condenser which is widely used in refrigerators, air conditioning is of type. - When the refrigerator is turned on, the condenser will be warm to the touch. - In its early stages, the condenser is placed behind the refrigerator, but at present, it is placed in the body of the refrigerator. - It can reduce the occurrence of rust on the body of the refrigerator in addition to making it more attractive fridge.
- The filter works by filtering out impurities resulting from the erosion of refrigerant in the system punto seco of the refrigerator. - Debris and dirt pipe as far as possible not to get into the compressor and it is filtered by this filter. - Filters must be capable of filtering impurities that may enter the system, such as rust, metal chips or copper welding when the work is done. 9. Capillary Tubes / Capillary punto seco Tube.
- Refrigerator punto seco not use a mechanical device as the refrigerant flow control. It uses a capillary tube or capillary tube. - Basically, the capillary tube is a small tube. The flow rate of the coolant is determined by the length of the tube and the inner diameter of the hole. - The coolant will continue to flow through the capillaries when the compressor stops until the pressure in the system (the high side and low side) are at the same pressure. - Capillary tube is usually located after the filter filters, punto seco it sometimes formed into a tight coil around punto seco the suction line. - It will be noted that the actual capillary tube evaporator through the suction punto seco line and thus provide heat exchange characteristics that enhance the performance of the compressor. 10. Adjuster Temperature / Thermostat.
- The thermostat also known as temperature controller. It serves to control the temperature automatically based on temperature readings on each side of the refrigerator. - It is like an automatic switch that works by controlling the temperature. - If the evaporator temperature has reached the set temperature on the thermostat, it will decide the electricity supply to the compressor. 11. Defrost Heater / Defrost Heater.
- Heating or R